|
|
Anti-theft wheel bolts Fig. 333 Anti-theft wheel bolt and upper section The anti-theft wheel bolts protect the wheels from theft. The upper section B
must be used to loosen/tighten these. › Insert the upper section B on the anti-theft wheel bolt A until it stops. › Insert the wrench on the attachment B until it stops and loose/tighten the wheel bolt. › Removing the upper section. The attachment for the anti-theft wheel bolts must always be kept in the vehicle in case of a possible wheel change! anti-theft wheel bolt should be installed in the position marked on the back of the wheel trim. Note We recommend that you retain the label with the code number. A replacement upper section can be acquired from ŠKODA original parts based on this. Loosening/tightening wheel bolts Fig. 334 Loosening the wheel bolts › Push the wheel wrench onto the wheel bolt to the stop. Use the associated upper section for the anti-theft wheel bolts › To loosen the screws, hold the wrench end and turn the screw about one turn in the direction of arrow › To tighten the screws, hold the wrench end and turn the screw against the direction of the arrow WARNING If it proves difficult to undo the bolts, carefully apply pressure to the end of the wrench with your foot. Keep hold of the vehicle when doing so, and make sure you keep your footing - risk of accident. Raising the vehicle Fig. 335 Jacking points for the jack Fig. 336 Attach lifting jack Before the vehicle is raised, the safety instructions must be observed . Use the jack from the tool kit to raise the vehicle. Position the jack at the jack- ing point closest to the wheel to be replaced. 285 Emergency equipment and self-help |