|
|
Content .. 1425 1426 1427 1428 ..
TM-52 < DISASSEMBLY AND ASSEMBLY > [6MT: RS6F52A] TRANSAXLE ASSEMBLY • When adjusting striking rod end play, select adjusting shim (1) for striking rod (2). To select adjusting shim, measure clearance between transaxle case (3) and striking rod shim (4). CAUTION: Only 1 adjusting shim can be selected. • Calculate dimension “R” (thickness of adjusting shim) using the fol- lowing procedure to satisfy specification of end play for striking rod. 1. Using a depth micrometer (A) and straightedge (B), measure dimension “R 1 ” between transaxle case (1) end face and mount- ing face of adjusting shim. CAUTION: “R 1 ”: Measure at 4 point by approximately 90 degrees and use the average value. 2. Using a depth micrometer (A) and straightedge (B) as shown, measure dimension “R 2 ” between clutch housing (1) end face and end face of striking rod shim (2). CAUTION: • “R 2 ”: Measure at 4 point by approximately 90 degrees and use the average value. • When measuring, be careful for the inclination of striking rod assembly and striking rod shim. 3. Install selected striking rod adjusting shim onto striking rod assembly. MAINSHAFT END PLAY • When adjusting mainshaft end play, select adjusting shim (1) for mainshaft rear bearing (2). To select adjusting shim, measure clearance “M” between transaxle case (3) and dummy adjusting shim (4) on mainshaft rear bearing. CAUTION: Only 1 adjusting shim can be selected. • Calculate dimension “P” (thickness of adjusting shim) using the fol- lowing procedure to satisfy specification of end play for mainshaft rear bearing. End play : Refer to . Dimension “R” = (R 1 - R 2 ) - End play R : Thickness of adjusting shim R 1 : Distance between transaxle case end face R 2 : Distance between clutch housing end face PCIB1823E PCIB1824E PCIB1825E 5 : Snap ring 6 : Mainshaft End play : Refer to Dimension “P” = (M + N) - End play PCIB1880E |