|
|
Content .. 1424 1425 1426 1427 ..
TM-48 < DISASSEMBLY AND ASSEMBLY > [6MT: RS6F52A] TRANSAXLE ASSEMBLY 29. Install guide bolt (1) according to the following: lever A is securely set to neutral position (A). If it is not in the neutral position (B), repeat the procedure from step a. CAUTION: The guide groove (D) of striking rod assembly will be dam- aged when assembling guide bolt (1) if the lever is not in the neutral position (B). c. Check continuity between terminals of park/neutral position (PNP) switch to confirm it in the neutral position. If it is not in the neutral position, remove park/neutral position (PNP) switch and repeat the procedure from step a. Refer to . d. Install guide bolt to transaxle case and then tighten guide bolt to the specified torque. CAUTION: Do not reuse guide bolt. 30. Apply recommended sealant to threads of park/neutral position (PNP) switch (1). Then install it to transaxle case and tighten to the specified torque. • Use Genuine Silicone RTV or an equivalent. Refer to 15, "Recommended Chemical Products and Sealants" . CAUTION: Remove old sealant and oil adhering to threads. 31. Install plunger to transaxle case. (2). Then install it to transaxle case and tighten to the specified torque. • Use Genuine Silicone RTV or an equivalent. Refer to 15, "Recommended Chemical Products and Sealants" . CAUTION: Remove old sealant and oil adhering to threads. 33. Install air breather tube (3) to transaxle case. CAUTION: • Do not reuse air breather tube. • Assemble air breather tube until its collar element contacts with transaxle case. PCIB1890E PCIB1836E PCIB1835E |