|
|
EM-224 < DISASSEMBLY AND ASSEMBLY > [VK56DE] ENGINE UNIT • Tap the rear oil seal until it is level with the rear end surface of rear oil seal retainer. 9. Install rear oil seal retainer. • Apply liquid gasket thoroughly to rear oil seal retainer as shown. Use Genuine RTV Silicone Sealant or equivalent. Refer to GI-14, "Recommended Chemical Products and Sealants" . • Apply new engine oil on the lips of rear oil seal. Do not touch. 10. Install the piston to the connecting rod. • Insert it fully into the groove to install. b. Install the piston to the connecting rod. • Heat piston until piston pin can be pushed in by hand without excess force [approx. 60 ° to 70 C ° (140 ° to 158 ° F)]. From the front to the rear, insert the piston pin into the piston and the connecting rod. • Assemble so that the front mark on the piston crown and the oil holes and cylinder No. on the connecting rod are positioned as shown. c. Install the snap ring to the grooves of the piston front side. • Insert it fully into the groove to install. • After installing, make sure connecting rod moves smoothly. 11. Install piston rings. CAUTION: Do not damage piston. • Position each ring with the gap as shown, referring to the pis- ton front mark. • Install the second ring with the stamped surface facing upward. PBIC0097E SBIA0391E KBIA2534E Stamped mark Second ring : 2N PBIC0100E 2010 Pathfinder |