|
|
EM-208 < ON-VEHICLE REPAIR > [VK56DE] CYLINDER HEAD 6. Install the valve springs. • Install the narrow pitch end (paint mark side) to the cylinder head side. 7. Install the valve spring retainers. 8. Install the valve collet using Tool. CAUTION: When working, take care not to damage valve lifter holes. 9. Install the valve lifters. • Install the removed parts in their original locations. • If installing new lifters, select the correct size lifter for proper valve clearance. Refer to . 10. Install the spark plug tube if necessary, following the procedure below. press-fit side. Use Genuine RTV Silicone Sealant or equivalent. Refer to GI-14, "Recommended Chemical Prod- . c. Press-fit the spark plug tube to the specified height “H” using suitable tool. CAUTION: • When press-fitting, take care not to deform the spark plug tube. • After press-fitting, wipe off any liquid gasket protruding onto the cylinder-head upper face. 11. Install the spark plugs. Inspection After Disassembly INFOID:0000000005260532 CYLINDER HEAD DISTORTION 1. Remove any oil, scale, gasket, sealant and carbon deposits from the cylinder head surface. CAUTION: Do not allow any debris to enter the oil or coolant passages. SEM085D Tool number : KV10116200 (J-26336-B) WBIA0578E Standard press-fit height “H” :38.400 - 39.400 mm KBIA1248E 2010 Pathfinder |