|
|
PWC-42 < DTC/CIRCUIT DIAGNOSIS > ENCODER CIRCUIT Is the inspection result normal? YES >> Replace rear power window switch RH. Refer to PWC-66, "Removal and Installation" NO >> GO TO 2. 2. CHECK ENCODER SIGNAL CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect rear power window switch RH connector and rear power window motor RH connector. 3. Check continuity between rear power window switch RH harness connector and rear power window motor 4. Check continuity rear power window switch RH harness connector and ground. Is the inspection result normal? YES >> GO TO 3. NO >> Repair or replace harness. 3. CHECK ENCODER POWER SUPPLY 1. Connect rear power window switch RH connector. 2. Turn ignition switch ON. 3. Check voltage between rear power window motor RH harness connector and ground. Is the inspection result normal? YES >> GO TO 5. NO >> GO TO 4. 4. CHECK ENCORDER POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect rear power window switch RH connector. 3. Check continuity between rear power window switch RH harness connector and rear power window motor JMKIA5210GB Rear power window switch RH Rear power window motor RH Continuity Connector Terminal Connector Terminal B222 12 B221 5 Existed 15 6 Rear power window switch RH Ground Continuity Connector Terminal B222 12 Not existed 15 (+) (–) Voltage (V) (Approx.) Rear power window motor RH Connector Terminal B221 2 Ground 12 Revision: 2013 February 2012 Murano CrossCabriolet |