Nissan Altima L32. Manual - part 861

BODY SIDE TRIM

INT-37

< ON-VEHICLE REPAIR >

[SEDAN]

C

D

E

F

G

H

I

K

L

M

A

B

INT

N

O

P

3. Release the clips, then remove rear pillar finisher.

SILL PLATE COVER (FRONT/REAR)

Release the pawls, then remove the sill plate cover.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

Make sure that clips are fully aligned with panel holes on body when installing, then press them in

completely.

INT-38

< ON-VEHICLE REPAIR >

[SEDAN]

REAR PARCEL SHELF FINISHER

REAR PARCEL SHELF FINISHER

Exploded View

INFOID:0000000004205978

Removal and Installation

INFOID:0000000004205979

REMOVAL

1. Release seatback latch RH/LH, then fold both rear seatbacks to forward most position.
2. Remove the clips, then remove rear seatback latch cover.
3. Lift seatback release cover, release the tabs and remove seatback release escutcheon from rear parcel

shelf finisher.

4. Remove high mounted stop lamp (if equipped). Refer to 

INT-36, "Removal and Installation"

.

5. Remove rear pillar finisher RH/LH. Refer to 

INT-36, "Removal and Installation"

.

6. Thread the rear seat belt RH/LH/Center through vertical opening and release from rear parcel shelf fin-

isher.

7. Remove the clips, then remove rear parcel shelf finisher.

1.

Seatback release escutcheon

2.

Seatback release cover

3.

Child anchor cover

4.

Seatback latch cover

5.

Rear parcel shelf finisher

6.

High mounted stop lamp (if equipped)

A.

Clip C205

Clip C101

Vehicle front

ALJIA0003ZZ

REAR PARCEL SHELF FINISHER

INT-39

< ON-VEHICLE REPAIR >

[SEDAN]

C

D

E

F

G

H

I

K

L

M

A

B

INT

N

O

P

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

Make sure that clips are fully aligned with panel holes on body when installing, then press them in

completely.

INT-40

< ON-VEHICLE REPAIR >

[SEDAN]

FLOOR TRIM

FLOOR TRIM

Exploded View

INFOID:0000000004205980

Removal and Installation

INFOID:0000000004205981

REMOVAL

1. Remove front seat (RH/LH) and rear seat cushion. Refer to 

SE-51, "Removal and Installation"

 and 

SE-53,

"Removal and Installation"

.

2. Remove lower body side trim. Refer to 

INT-36, "Removal and Installation"

.

3. Remove center console. Refer to 

IP-12, "Removal and Installation"

.

1.

Spacer (RH)

2.

Spacer (LH)

3.

Floor mat hook

4.

Floor carpet

5.

Harness clamp

Vehicle front

ALJIA0004ZZ