Nissan Altima L32. Manual - part 744

EXL-260

< ON-VEHICLE REPAIR >

REAR COMBINATION LAMP

REAR COMBINATION LAMP

Bulb Replacement

INFOID:0000000004201566

REAR TURN SIGNAL LAMP

Removal

1. Remove the rear combination lamp. Refer to 

EXL-260, "Removal and Installation"

.

2. Turn the rear turn signal lamp bulb socket counterclockwise and remove it.
3. Remove the rear turn signal lamp bulb.

Installation

Installation is in the reverse order of removal.

STOP/TAIL LAMP

Removal

1. Remove the rear combination lamp. Refer to 

EXL-260, "Removal and Installation"

.

2. Turn the stop/tail lamp bulb socket counterclockwise and remove it.
3. Remove the stop/tail lamp bulb.

Installation

Installation is in the reverse order of removal.

BACK-UP LAMP

Removal

1. Remove the rear combination lamp. Refer to 

EXL-260, "Removal and Installation"

.

2. Turn the back-up lamp bulb socket counterclockwise and remove it.
3. Remove the back-up lamp bulb.

Installation

Installation is in the reverse order of removal.

SIDE MARKER LAMP

Removal

1. Remove the rear combination lamp. Refer to 

EXL-260, "Removal and Installation"

.

2. Turn the side marker lamp bulb socket counterclockwise and remove it.
3. Remove the side marker lamp bulb.

Installation

Installation is in the reverse order of removal.

Removal and Installation

INFOID:0000000004201567

COMPONENTS

REAR COMBINATION LAMP

EXL-261

< ON-VEHICLE REPAIR >

C

D

E

F

G

H

I

J

K

M

A

B

EXL

N

O

P

REMOVAL

1. Remove trunk side finisher. Refer to 

INT-23, "Removal and Installation"

.

2. Remove the rear combination lamp nuts.
3. Pull the rear combination lamp assembly toward rear of the vehicle and remove.

INSTALLATION

Installation is the reverse order of removal.

1.

Rear combination lamp assembly

2.

Back-up lamp bulb

3.

Stop/Tail lamp bulb

4.

Rear combination lamp harness

5.

Side marker lamp bulb

6.

Rear turn signal lamp bulb

ALLIA0039ZZ

EXL-262

< ON-VEHICLE REPAIR >

LIGHTING AND TURN SIGNAL SWITCH

LIGHTING AND TURN SIGNAL SWITCH

Removal and Installation

INFOID:0000000004201568

Removal

1. Remove the spiral cable. Refer to 

SR-8, "Removal and Installation"

2. Disconnect the lighting and turn signal switch connector and remove the lighting and turn signal switch.

Installation

Installation is in the reverse order of removal.

HAZARD SWITCH

EXL-263

< ON-VEHICLE REPAIR >

C

D

E

F

G

H

I

J

K

M

A

B

EXL

N

O

P

HAZARD SWITCH

Removal and Installation

INFOID:0000000004201569

Removal

1. Remove the cluster lid C. Refer to 

IP-12, "Removal and Installation"

.

2. Remove CVT finisher or M/T finisher. Refer to 

TM-255, "Removal and Installation"

 or 

TM-21, "Removal

and Installation"

.

3. Remove the hazard switch screws (A) and remove the hazard

switch. (1). 

Installation

Installation is in the reverse order of removal.

ALLIA0037ZZ