|
|
P0122, P0123 TP SENSOR EC-1217 < COMPONENT DIAGNOSIS > [VQ35DE] C D E F G H I J K L M A EC N P O GI-42, "Intermittent Incident" . >> INSPECTION END Component Inspection INFOID:0000000004362068 1. CHECK THROTTLE POSITION SENSOR 1. Turn ignition switch OFF. 2. Reconnect all harness connectors disconnected. 3. Perform EC-1053, "THROTTLE VALVE CLOSED POSITION LEARNING : Special Repair Requirement" 4. Turn ignition switch ON. 5. Set selector lever position to D (CVT) or 1st position (M/T). 6. Check the voltage between ECM harness connector terminals under the following conditions. Is the inspection result normal? YES >> INSPECTION END NO >> GO TO 2. 2. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR 1. Replace electric throttle control actuator. 2. Go to EC-1217, "Special Repair Requirement" >> INSPECTION END Special Repair Requirement INFOID:0000000004362069 1. PERFORM THROTTLE VALVE CLOSED POSITION LEARNING EC-1053, "THROTTLE VALVE CLOSED POSITION LEARNING : Special Repair Requirement" >> GO TO 2. 2. PERFORM IDLE AIR VOLUME LEARNING EC-1053, "IDLE AIR VOLUME LEARNING : Special Repair Requirement" >> END ECM Condition Voltage Con- nector + – Terminal Terminal F13 37 (TP sensor 1 signal) 36 (Sensor Accelera- tor pedal Fully released More than 0.36 V Fully depressed Less than 4.75 V 38 (TP sensor 2 signal) Fully released Less than 4.75 V Fully depressed More than 0.36 V JMBIA1953ZZ |