|
|
P0101 MAF SENSOR EC-173 < COMPONENT DIAGNOSIS > [QR25DE FOR CALIFORNIA] C D E F G H I J K L M A EC N P O *: Check for linear voltage rise in response to engine being increased to about 4,000 rpm. Without CONSULT-III 1. Repair or replace malfunctioning part. 2. Start engine and warm it up to normal operating temperature. 3. Check the voltage between ECM harness connector and ground. *: Check for linear voltage rise in response to engine being increased to about 4,000 rpm. Is the inspection result normal? YES >> INSPECTION END NO >> GO TO 4. 4. CHECK MASS AIR FLOW SENSOR-III With CONSULT-III 1. Turn ignition switch OFF. 2. Disconnect mass air flow sensor harness connector and reconnect it again. 3. Start engine and warm it up to normal operating temperature. 4. Connect CONSULT-III and select “DATA MONITOR” mode. 5. Select “MAS A/F SE-B1” and check indication. *: Check for linear voltage rise in response to engine being increased to about 4,000 rpm. Without CONSULT-III 1. Turn ignition switch OFF. 2. Disconnect mass air flow sensor harness connector and reconnect it again. 3. Start engine and warm it up to normal operating temperature. Monitor item Condition MAS A/F SE-B1 MAS A/F SE-B1 Ignition switch ON (Engine stopped.) Approx. 0.4 V Idle (Engine is warmed-up to normal operating temperature.) 0.9 - 1.1 V 2,500 rpm (Engine is warmed-up to normal operating temperature.) 1.4 - 1.7 V Idle to about 4,000 rpm 0.9 - 1.1 V to Approx. 2.4 V* ECM Ground Condition Voltage Connector Terminal F13 58 (MAF sensor Ground Ignition switch ON (Engine Approx. 0.4 V Idle (Engine is warmed-up to 0.9 - 1.1 V 2,500 rpm (Engine is 1.4 - 1.7 V Idle to about 4,000 rpm 0.9 - 1.1 V to Approx. 2.4 V* PBIB3481E Monitor item Condition MAS A/F SE-B1 MAS A/F SE-B1 Ignition switch ON (Engine stopped.) Approx. 0.4 V Idle (Engine is warmed-up to normal operating temperature.) 0.9 - 1.1 V 2,500 rpm (Engine is warmed-up to normal operating temperature.) 1.4 - 1.7 V Idle to about 4,000 rpm 0.9 - 1.1 V to Approx. 2.4 V* |