|
|
BR-18 < ON-VEHICLE REPAIR > BRAKE TUBE AND HOSE BRAKE TUBE AND HOSE Hydraulic Circuit INFOID:0000000004499310 Four Channel Hydraulic Circuit CAUTION: • All hoses and piping (tubes) must be free from excessive bending, twisting and pulling. • Make sure there is no interference with other parts when turning steering both clockwise and coun- terclockwise. • The brake piping is an important safety part. If a brake fluid leak is detected, always disassemble the parts. Replace applicable part with a new one, if necessary. • Be careful not to splash brake fluid on painted areas; it way cause paint damage. If brake fluid is splashed on painted areas, wash it away with water immediately. • Do not bend or twist brake hose sharply, or strongly pull it. • When removing components, cover connections so that no dirt, dust, or other foreign matter gets in. • Do not reuse drained brake fluid. • After installation of the ABS actuator and electric unit (control unit), refill brake system with new brake fluid. Then bleed the air from the system. Refer to BR-16, "Bleeding Brake System" . FRONT BRAKE INFOID:0000000004499308 REMOVAL CAUTION: • Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on painted areas, wash it away with water immediately. • Cover the open end of brake tubes and hoses when disconnecting to prevent entrance of dirt. AWFIA0504ZZ 1. ABS actuator and electric unit 2. Master cylinder 3. Booster 4. Connector A. Union bolt B. Flare nut M12 C. Flare nut M10 |