|
|
Content .. 1283 1284 1285 1286 ..
SEC-290 < COMPONENT DIAGNOSIS > [SEDAN WITH INTELLIGENT KEY] B2608 STARTER RELAY B2608 STARTER RELAY Description INFOID:0000000004206249 Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic INFOID:0000000004206250 DTC DETECTION LOGIC NOTE: • If DTC B2608 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to • If DTC B2608 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to DTC CONFIRMATION PROCEDURE 1. PERFORM DTC CONFIRMATION PROCEDURE 1. Press the push-button ignition switch under the following conditions. - CVT selector lever is in the P or N position. - Depress the brake pedal. 2. Check “Self diagnostic result” with CONSULT-III. YES >> Refer to SEC-290, "Diagnosis Procedure" NO >> Inspection End. Diagnosis Procedure INFOID:0000000004206251 1. CHECK STARTER RELAY 1. Turn ignition switch ON. 2. Check voltage between BCM harness connector and ground under the following condition. DTC No. Trouble diagnosis name DTC detecting condition Possible cause B2608 STARTER RELAY BCM receives starter relay ON signal (CAN) from • Harness or connectors (starter relay circuit is open or • IPDM E/R ALKIA0452ZZ BCM Ground Condition Voltage (V) Connector Terminal M21 132 Ground CVT selector lever N or P position Battery voltage Other than above 0 Clutch pedal Not depressed 0 Depressed Battery voltage |