|
|
Content .. 1186 1187 1188 1189 ..
RF-94 < ON-VEHICLE REPAIR > SUNROOF UNIT ASSEMBLY Unit: mm (in) Gap adjustment (A-A, C-C) 1. Open sunshade assembly (1). sides), then tilt glass lid assembly down. 4. Manually adjust glass lid assembly from outside of vehicle so gaps A-A and C-C are within specifications. NOTE: Temporarily snug glass lid assembly bolts to prevent movement between each adjustment. 5. Tilt glass lid assembly up and down several times using sunroof switch to check that it operates smoothly. 6. Tilt glass lid assembly up and tighten bolts to specification. NOTE: First tighten left front bolt, then right rear bolt on glass lid assem- bly to prevent uneven torque while tightening remaining bolts. 7. Attach side trim cover, then tilt glass lid assembly down. Gap Adjustment (B-B) 1. Remove headlining. For Sedan Refer to INT-42, "Removal and Installation" 2. Loosen sunroof unit assembly and sunroof side bracket bolts. NOTE: Temporarily snug sunroof unit assembly bolts to prevent movement between each adjustment. 4. Tilt glass lid assembly up and down several times using sunroof switch to check that it operates smoothly. NOTE: First tighten left front sunroof unit assembly bolt, then right rear to prevent uneven torque while tightening remaining bolts. 6. Install headlining. For Sedan Refer to INT-42, "Removal and Installation" Height Adjustment 1. Tilt glass lid assembly up and down several times using sunroof switch to check that it operates smoothly. tions. 3. If necessary, adjust height difference by using the following procedure. • Loosen glass lid assembly bolts. • Manually raise/lower glass lid assembly until height difference is within specification. NOTE: If necessary, shims may be added between sunroof unit assembly and roof to increase adjustment range. Refer to Temporarily snug sunroof unit assembly bolts to prevent movement between each adjustment. • Tilt glass lid assembly up and down several times using sunroof switch to check that it operates smoothly. • Tighten glass lid assembly and sunroof side bracket bolts. NOTE: First tighten left front bolt, then right rear bolt on glass lid assembly to prevent uneven torque while tight- ening remaining bolts. • After any adjustment, check sunroof operation and glass lid assembly alignment. A-A B-B C-C D. 1.4 ± 0.45 (0.06 ± 0.02) 1.4 ± 0.45 (0.06 ± 0.02) 1.4 ± 0.45 (0.06 ± 0.02) E. 5.8 ± (0.23) 5.8 ± (0.23) 5.8 ± (0.23) F. -0.8 ± 1.5 (-0.03 ± 0.06) -0.8 ± 1.5 (-0.03 ± 0.06) -0.8 ± 1.5 (-0.03 ± 0.06) ALKIA0059ZZ |