|
|
Content .. 1130 1131 1132 1133 ..
INSPECTION AND ADJUSTMENT PWC-295 < BASIC INSPECTION > [LH&RH FRONT ANTI-PINCH-SEDAN] C D E F G H I J L M A B PWC N O P INSPECTION AND ADJUSTMENT ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL INFOID:0000000004205140 Initial setting is necessary when battery terminal is removed. CAUTION: The following specified operations are not performed under the non-initialized condition. • Auto-up operation • Anti-pinch function • Retained power operation ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Spe- INFOID:0000000004205141 INITIALIZATION PROCEDURE 1. Disconnect battery minus terminal or power window main switch connector. Reconnect it after a minute or more. 2. Turn ignition switch ON. 3. Operate power window switch to fully open the window. (This operation is unnecessary if the window is already fully open) 4. Continue pulling the power window switch UP (AUTO-UP operation). Even after glass stops at fully closed position, keep pulling the switch for 4 seconds or more. 5. Inspect anti-pinch function. CHECK ANTI-PINCH FUNCTION 1. Fully open the door window. 2. Place a piece of wood near fully closed position. 3. Close door glass completely with AUTO-UP. • Check that glass lowers for approximately 150 mm or 2 seconds without pinching piece of wood and stops. • Check that glass does not rise when operating the power window main switch while lowering. CAUTION: • Do not check with hands and other part of body because they may be pinched. Do not get pinched. • Check that AUTO-UP operates before inspection when system initialization is performed. • It may switch to fail-safe mode if open/close operation is performed continuously. Perform initial set- ting in that situation. Refer to . • Perform initial setting when auto-up operation or anti-pinch function does not operate normally. • Finish initial setting. Otherwise, next operation cannot be done. 1. Auto-up operation 2. Anti-pinch function 3. Retained power operation when ignition switch is OFF. ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT INFOID:0000000004205142 Initial setting is necessary when replacing power window main switch. CAUTION: The following specified operations are not performed under the non-initialized condition. • Auto-up operation • Anti-pinch function • Retained power operation ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Re- INFOID:0000000004205143 INITIALIZATION PROCEDURE 1. Disconnect battery minus terminal or power window main switch connector. Reconnect it after a minute or more. |