|
|
Content .. 1106 1107 1108 1109 ..
POWER SUPPLY AND GROUND CIRCUIT PWC-199 < COMPONENT DIAGNOSIS > [LH&RH FRONT ANTI-PINCH-COUPE] C D E F G H I J L M A B PWC N O P Is the inspection result normal? YES >> GO TO 4 NO >> Repair or replace harness. 3. CHECK GROUND CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect main power window and door lock/unlock switch. 3. Check continuity between main power window and door lock/ unlock switch connector and ground. Is the inspection result normal? YES >> Replace main power window and door lock/unlock switch. Refer to PWC-291, "Removal and Installation" After that, refer to PWC-190, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : . NO >> Repair or replace harness. 4. CHECK BCM OUTPUT SIGNAL 1. Connect BCM. 2. Turn ignition switch ON. 3. Check voltage between BCM connector and ground. Is the measurement value within the specification? YES >> Replace main power window and door lock/unlock switch. Refer to PWC-190, "ADDITIONAL SERVICE WHEN REPLACING CON- TROL UNIT : Special Repair Requirement" . NO >> Replace BCM. Refer to BCS-96, "Removal and Installation" POWER WINDOW MAIN SWITCH : Special Repair Requirement INFOID:0000000004205079 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-190, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Require- Is the inspection result normal? YES >> GO TO 2 NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident" . 2. CHECK ANTI-PINCH OPERATION Check anti-pinch operation. Refer to PWC-190, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Require- BCM connector Terminal Ground Continuity M16 3 No 2 Main power window and door lock/ unlock switch connector Terminal Ground Continuity D7 15 Yes LIIA0604E Terminals Voltage (V) (Approx.) (+) (–) BCM connector Terminal M16 3 Ground Battery voltage 2 ALKIA0262ZZ |