|
|
Component Description CRANKSHAFT POSITION SENSOR (TDC) The crankshaft position sensor (TDC) monitors engine speed by On Board Diagnosis Logic DTC Malfunction is detected when .... Check Items (Possible cause) P0335 I An improper signal from the sensor is detected by I Harness or connectors I Crankshaft position sensor (TDC) DTC Confirmation Procedure I If DTC P1240 is displayed same time, perform trouble diag- I Before performing the following procedure, confirm that WITH CONSULT-II 1) Turn ignition switch to “ON” position and select “DATA MONI- TOR” mode with CONSULT-II. 2) Start engine and run it for at least 3 seconds at above 1,200 rpm. WITHOUT CONSULT-II 1) Start engine and run it for at least 3 seconds at above 1,200 rpm. 2) Turn ignition switch to “LOCK” position, wait at least 5 seconds and then turn to “ON” position. 3) Perform “Diagnostic Test Mode II” (Self-diagnostic results). NEF710 NEF711 DTC P0335 CRANK POS SEN (TDC) TD27Ti EC-385 |