|
|
TRANSMISSION ASSEMBLY TM-215 < UNIT REMOVAL AND INSTALLATION > C E F G H I J K L M A B TM N O P 8. Remove crankshaft position sensor (POS) from A/T assembly. CAUTION: • Do not subject it to impact by dropping or hitting it. • Do not disassemble. • Do not allow metal filings or foreign material to get on the sensor front edge magnetic area. • Do not place in an area affected by magnetism. 9. Remove A/T fluid cooler tubes from A/T assembly. CAUTION: Do not reuse copper sealing washers. 10. Remove dust cover from converter housing. plate and torque converter. CAUTION: When turning crankshaft, turn it clockwise as viewed from the front of the engine. 12. Support A/T assembly using transmission jack and Tool. CAUTION: When setting the transmission jack, be careful not to allow it to collide against the drain plug. 13. Remove cross member using power tool. breather hose. Refer to TM-195, "4WD : Removal and Installation" . 15. Remove air breather hose. Refer to TM-195, "4WD : Removal and Installation" . 16. Disconnect the following. • Neutral 4 low switch • Wait detection switch • Transfer motor connector • A/T assembly connector • Transfer control device connector • ATP switch connector • Transfer terminal cord assembly connector 17. Remove A/T fluid indicator pipe. CAUTION: Do not reuse O-ring. 18. Remove A/T assembly to engine bolts using power tool. CAUTION: • Secure torque converter to prevent it from dropping. • Secure A/T assembly to transmission jack. 20. Remove transfer from A/T assembly. Refer to INSPECTION LCIA0334E LCIA0335E Tool number : — (J-47002) SCIA2203E |