|
|
INTAKE MANIFOLD EM-29 < REMOVAL AND INSTALLATION > C D E F G H I J K L M A EM N P O 5. Install the quick connector cap on the quick connector joint (on engine side only). 6. Install the fuel hose and tube to hose clamps. INSPECTION AFTER INSTALLATION • After installing fuel tubes, make sure there is no fuel leakage at connections in the following steps. - Apply fuel pressure to fuel lines by turning ignition switch ON (with engine stopped). Then check for fuel leaks at connections. - Start the engine and rev it up and check for fuel leaks at the connections. • Perform procedures for “Throttle Valve Closed Position Learning” after finishing repairs. Refer to "Throttle Valve Closed Position Learning" • If electric throttle control actuator is replaced, perform procedures for “Idle Air Volume Learning” after finish- ing repairs. Refer to EC-120, "Idle Air Volume Learning" . SBIA0354E |