|
|
FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY FL-7 < REMOVAL AND INSTALLATION > C D E F G H I J K L M A FL N P O 9. Remove fuel level sensor unit, fuel filter and fuel pump assembly. Remove and discard the O-ring. CAUTION: • Do not bend the float arm during removal. • Do not reuse O-ring. INSPECTION AFTER REMOVAL Inspect the fuel level sensor, fuel filter, and fuel pump assembly for any defects and foreign materials. Replace as necessary. INSTALLATION Installation is in the reverse order of removal. • Install the fuel level sensor, fuel filter, and fuel pump assembly with the fuel feed tube (C) facing the front of the vehicle as shown. Use a new O-ring. CAUTION: Do not reuse O-ring. • Install the lock ring using Tool (A). NOTE: For reference when installing, align the matching marks on lock ring, fuel pump assembly and fuel tank. • Connect the quick connector as follows: - Check the connection for damage or any foreign materials. - Align the connector with the tube, then insert the connector straight into the tube until a click is heard. • After the tube is connected, make sure the connection is secure by performing the following checks: - Pull (A) the tube and the connector to make sure they are securely connected. : Front (A) : EVAP tube (B) : Harness connector ALBIA0747ZZ Tool number : KV10119900 (J-45722) JPBIA3556ZZ JPBIA0140ZZ |