|
|
IDLE AIR VOLUME LEARNING EC-115 < BASIC INSPECTION > [HR16DE] C D E F G H I J K L M A EC N P O IDLE AIR VOLUME LEARNING Description INFOID:0000000009022486 Idle Air Volume Learning is a function of ECM to learn the idle air volume that keeps each engine idle speed within the specific range. It must be performed under any of the following conditions: • Each time electric throttle control actuator or ECM is replaced. • Idle speed or ignition timing is out of specification. Work Procedure INFOID:0000000009022487 1. PRECONDITIONING Make sure that all of the following conditions are satisfied. Learning will be cancelled if any of the following conditions are missed for even a moment. • Battery voltage: More than 12.9 V (At idle) • Engine coolant temperature: 70 - 100 °C (158 - 212°F) • Selector lever: P or N (CVT), Neutral (M/T) • Electric load switch: OFF (Air conditioner, headlamp, rear window defogger) - For vehicles equipped with daytime light systems, perform one of the following procedures before starting engine not to illuminate headlamps. • Apply parking brake • Set lighting switch to the 1st position • Steering wheel: Neutral (Straight-ahead position) position • Vehicle speed: Stopped • Transmission: Warmed-up - CVT models • With CONSULT: Drive vehicle until “FLUID TEMP SE” in “DATA MONITOR” mode of “TRANSMISSION” sys- tem indicates less than 0.9 V. • Without CONSULT: Drive vehicle for 10 minutes. - M/T models • Drive vehicle for 10 minutes. YES >> GO TO 2. NO >> GO TO 3. 2. IDLE AIR VOLUME LEARNING With CONSULT 1. Perform ACCELERATOR PEDAL RELEASED POSITION LEARNING. Refer to 2. Perform THROTTLE VALVE CLOSED POSITION LEARNING. Refer to 3. Start engine and warm it up to normal operating temperature. 4. Select “IDLE AIR VOL LEARN” in “WORK SUPPORT” mode with CONSULT. 5. Touch “START” and wait 20 seconds. YES >> GO TO 4. NO >> GO TO 5. 3. IDLE AIR VOLUME LEARNING Without CONSULT NOTE: • It is better to count the time accurately with a clock. • It is impossible to switch the diagnostic mode when an accelerator pedal position sensor circuit has a malfunction. 1. Perform ACCELERATOR PEDAL RELEASED POSITION LEARNING. Refer to 2. Perform THROTTLE VALVE CLOSED POSITION LEARNING. Refer to 3. Start engine and warm it up to normal operating temperature. 4. Turn ignition switch OFF and wait at least 10 seconds. |