|
|
INT-34 < REMOVAL AND INSTALLATION > HEADLINING • Be careful not to bend or crease the headlining during removal or installation. REMOVAL 1. Recline the front seats to the fully reclined position. PG-67, "Removal and Installation (Bat- 3. Remove front pillar finishers (RH/LH). Refer to INT-24, "Removal and Installation" . 4. Disconnect headlining harness and antenna feeder connectors. INT-24, "Removal and Installation" 6. Remove rear pillar finishers (RH/LH). Refer to INT-24, "Removal and Installation" 7. Disconnect antenna amplifier and rear window defogger harness connectors. grips. 9. Remove the rear view mirror. Refer to MIR-19, "Removal and Installation" . 10. Remove the sun visors (RH/LH). into the sun visor holder notch on the front of the sun visor holder (1) and press in the locking tab (B) to release it. While holding in lock tab (B), turn the sun visor holder (1) 90 degrees to release it from the headliner. • If the sun visor holder (1) does not fully rotate, make sure that the suitable thin tool (A) is pressing in on the locking tab (B) and is not positioned under locking tab (B). Reinsert the suit- able thin tool (A) as necessary to release the locking tab (B). • : Front CAUTION: Do not force the sun visor holder when removing as the locking tab may be damaged if the suitable thin tool is not positioned correctly. 12. Remove front room/map lamp assembly. Refer to INL-84, "Removal and Installation" 13. Release dual lock fasteners around the sunroof opening and the magnets in the center of the headlining. Release the sunroof clip using a suitable tool. 14. Release the hidden clips near the rear edge of headlining using a suitable tool. PIIB3585J ALJIA0537ZZ |