|
|
EC-476 < DTC/CIRCUIT DIAGNOSIS > [VQ35DE] P2135 TP SENSOR 7. CHECK INTERMITTENT INCIDENT GI-41, "Intermittent Incident" >> INSPECTION END Component Inspection INFOID:0000000010095187 1. CHECK THROTTLE POSITION SENSOR 1. Turn ignition switch OFF. 2. Reconnect all harness connectors disconnected. 3. Perform EC-476, "Special Repair Requirement" 4. Turn ignition switch ON. 5. Set selector lever to D position. 6. Check the voltage between ECM harness connector terminals under the following conditions. Is the inspection result normal? YES >> INSPECTION END NO >> GO TO 2. 2. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR 1. Replace electric throttle control actuator. Refer to EM-25, "Removal and Installation" 2. Go to EC-476, "Special Repair Requirement" . >> INSPECTION END Special Repair Requirement INFOID:0000000010095188 1. PERFORM THROTTLE VALVE CLOSED POSITION LEARNING EC-21, "THROTTLE VALVE CLOSED POSITION LEARNING : Special Repair Requirement" >> GO TO 2. 2. PERFORM IDLE AIR VOLUME LEARNING EC-21, "IDLE AIR VOLUME LEARNING : Special Repair Requirement" >> END ECM Condition Voltage Connector + – Terminal Terminal F13 37 (TP sensor 1 signal) 36 (Sensor Accelerator pedal Fully re- leased More than 0.36 V Fully de- pressed Less than 4.75 V 38 (TP sensor 2 signal) Fully re- leased Less than 4.75 V Fully de- pressed More than 0.36 V JMBIA1864ZZ |