|
|
DLN-26 < DTC/CIRCUIT DIAGNOSIS > [TRANSFER: TX15B] P1807 VEHICLE SPEED SENSOR (A/T) P1807 VEHICLE SPEED SENSOR (A/T) Description INFOID:0000000009479641 The transmission control module (TCM) transmits the output shaft revolution signal via CAN communication to Transfer control unit. DTC P1807 will set when a malfunction is detected in the output shaft revolution signal or an improper signal is input while driving. DTC Logic INFOID:0000000009479642 DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Perform self-diagnosis. YES >> Perform diagnosis procedure. Refer to . NO >> Inspection End. Diagnosis Procedure INFOID:0000000009479643 1. CHECK DTC WITH TCM Perform self-diagnosis with TCM. Refer to TM-157, "CONSULT Function (TRANSMISSION)" Is any malfunction detected by self-diagnosis? YES >> Check the malfunctioning system. NO >> GO TO 2. 2. CHECK TRANSFER CONTROL UNIT Check transfer control unit input/output signal. Refer to Are the inspection results normal? YES >> GO TO 3. NO >> Check transfer control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts. 3. CHECK DTC Drive vehicle and then perform Self-diagnosis. YES >> Perform self-diagnosis with TCM again. NO >> Inspection End. DTC CONSULT Diagnostic item is detected when... Reference [P1807] VHCL SPEED SEN·AT • Malfunction is detected in output shaft revolution signalthat is output from • Improper signal is input while driving. |