|
|
BRC-236 < UNIT REMOVAL AND INSTALLATION > [TYPE 2] ACTUATOR AND ELECTRIC UNIT (ASSEMBLY) ACTUATOR AND ELECTRIC UNIT (ASSEMBLY) Removal and Installation INFOID:0000000009479557 NOTE: When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spill- ing. REMOVAL 1. Disconnect the negative battery terminal. Refer to PG-83, "Removal and Installation" 2. Remove air cleaner case. Refer to . 3. Disconnect the harness connector from the ABS actuator and electric unit (control unit). CAUTION: • To remove the brake tubes, use a flare nut wrench to prevent the flare nuts and brake tubes from being damaged. • Be careful not to splash brake fluid on painted areas. 4. Disconnect the brake tubes. INSTALLATION Installation is in the reverse order of removal. 1. From master cylinder secondary side 2. To rear right disc brake 3. To rear left disc brake 4. To front right disc brake 5. To front left disc brake 6. From master cylinder primary side 7. ABS actuator and electric unit (control unit) 8. Harness connector Front AWFIA0743GB |