|
|
Content .. 1155 1156 1157 1158 ..
SR-18 < REMOVAL AND INSTALLATION > SIDE CURTAIN AIR BAG MODULE SIDE CURTAIN AIR BAG MODULE Removal and Installation INFOID:0000000009480301 REMOVAL NOTE: Crew cab model shown, king cab similar CAUTION: • Do not attempt to repair or replace damaged direct-connect SRS component connectors. If a direct- connect harness connector is damaged, the harness must be replaced. • Before servicing the SRS, turn the ignition switch off, disconnect both battery terminals and wait at least three minutes. • When servicing the SRS, do not work from directly in front of air bag module. 2. Remove headlining. Refer to INT-25, "Removal and Installation" 3. Disconnect front and rear side curtain air bag module connectors. • For removal/installation of the direct-connect SRS connectors, refer to . 4. Remove the bolts in order starting at the front or rear, and remove the side curtain air bag module. CAUTION: • When servicing the SRS, do not work from directly in front of air bag module. • Do not insert any foreign objects (screwdriver, etc.) into air bag module or harness connectors. • Do not disassemble air bag module. • Do not expose the air bag module to temperatures exceeding 90 °C (194°F). • Replace side curtain air bag module if it has been dropped or sustained an impact. • Do not allow oil, grease or water to come in contact with the air bag module. INSTALLATION Installation is in the reverse order of removal. AWHIA0269GB 1. Side curtain air bag module connector SBF814E |