|
|
Content .. 1145 1146 1147 1148 ..
SN REAR SONAR SYSTEM SN-5 < SYSTEM DESCRIPTION > C D E F G H I J K L M B A O P SYSTEM DESCRIPTION REAR SONAR SYSTEM System Diagram INFOID:0000000009480099 System Description INFOID:0000000009480100 FUNCTION With power and ground supplied, transmission gear selector lever in R position, and the sonar system OFF switch ON, the rear sonar system will detect obstacles within 1.8 m (5.9 ft.) of the rear sonar sensors. The vehicle operator is notified of obstacles by varied rate of tone from the rear sonar buzzer depending on dis- tance of obstacle being sensed. SONAR SYSTEM OFF SWITCH With power and ground supplied to the sonar control unit, transmission gear selector lever in R position, the sonar system can be disabled and the sonar buzzer silenced by momentarily pressing the sonar system OFF switch. The sonar system OFF indicator lamp will be illuminated in the sonar system OFF switch. The rear sonar system and buzzer will be disabled and the sonar system OFF indicator will be illuminated until the ignition switch is turned OFF. When the ignition switch is turned ON, the rear sonar system will be enabled. Depressing the sonar system OFF switch again will enable the rear sonar system also. Enabling the rear sonar system will cause the rear sonar system OFF indicator to go out. If the sonar control unit detects a mal- function in the system it will turn off the sonar system and the indicator lamp will turn on. REAR SONAR BUZZER With power and ground supplied to the sonar control unit and the A/T selector lever in R position, a stationary object that is at least 7.0 cm (2.8 in.) wide and 1.0 m (39.0 in.) tall and that is closer than 1.8 m (5.9 ft.) will be detected by the rear sonar sensors, causing the rear sonar buzzer to sound a tone. As the vehicle moves closer to the object, the rate of the tone will increase. When the object is less than 25.0 cm (10 in.) from the rear bumper, the tone will sound continuously. REAR SONAR SENSORS With power and ground supplied to the rear sonar sensors, the sonar sensors transmit an ultrasonic signal. This signal is reflected back to the sensor by objects large enough and close enough to be detected. The rear sonar sensors measure the time from the transmitted signal to the time the signal is reflected back and sends this information to the sonar control unit. BACK-UP LAMP RELAY (WITH A/T) The back-up lamp relay provides a reverse signal to the sonar control unit. BACK-UP LAMP SWITCH (WITH M/T) The back-up lamp switch provides a reverse signal to the sonar control unit. AWNIA3304GB |