|
|
On Board Diagnosis Logic NMEC0691 DTC No. Malfunction is detected when ... Check Items (Possible Cause) 0201 I The ignition signal in the primary circuit is not sent to I Harness or connectors (The ignition primary cir- I Power transistor unit built into ignition coil I Condenser I Camshaft position sensor I Camshaft position sensor circuit SEC447C DTC Confirmation Procedure NMEC0692 NOTE: I If “DTC Confirmation Procedure” has been previously conducted, always turn ignition switch “OFF” and wait at least I If DTC 0201 is displayed with DTC 0101, perform trouble WITH CONSULT-II NMEC0692S01 1) Turn ignition switch “ON”. 2) Select “DATA MONITOR” mode with CONSULT-II. 3) Start engine. (If engine does not run, turn ignition switch to 4) If DTC is detected, go to “Diagnostic Procedure”, EC-114. WITHOUT CONSULT-II NMEC0692S02 1) Turn ignition switch “ON”. 2) Start engine. (If engine does not run, turn ignition switch to 3) Turn ignition switch “OFF”, wait at least 5 seconds and then 4) Perform “Diagnostic Test Mode II (Self-diagnostic results)” with 5) If DTC is detected, go to “Diagnostic Procedure”, EC-114. GI MA EM LC FE CL MT AT PD AX SU BR ST RS BT HA SC EL IDX DTC 0201 IGNITION SIGNAL On Board Diagnosis Logic EC-111 |