|
|
SMT747D a. Using dial gauge as shown in the figure, measure dimension SMT748D b. Using dial gauge as shown in the figure, measure dimension SMT646D 16. Using snap ring pliers as shown in the figure, install snap ring. CAUTION: Do not reuse snap ring. SMT753DA 18. Install reverse idler gear, O-ring, thrust washers (front, rear), and bearing onto reverse idler shaft. 19. Install snap ring into transaxle case using snap ring pliers. CAUTION: + Do not reuse snap ring. + Do not reuse O-ring. + Before installation, apply gear oil to O-ring. SMT754D 20. Using feeler gauge, measure the end play of snap ring, and select a snap ring suitable to satisfy the following specification. End play: 0.05 - 0.25 mm (0.0020 - 0.0098 in) Available snap ring: Refer to SDS, MT-90. ASSEMBLY RS5F70A Transaxle Case (Cont’d) MT-60 |