|
|
LAN-60 < SYSTEM DESCRIPTION > [CAN] TROUBLE DIAGNOSIS CAUTION: Never replace the unit even when “NG” is indicated on the “INITIAL DIAG” at this stage. Follow the trouble diagnosis proce- IPDM E/R 0: Error at present, 1 – 39: Error in the past (Number means the number of times the ignition switch is turned OFF → ON) *: 39 or higher number is fixed at 39 until the self-diagnosis result is erased. DTC Index INFOID:0000000007354990 ITEM CAN DIAG SUP- PORT MNTR Description Normal Error PRESENT ABS INITIAL DIAG Status of CAN controller OK NG Caution TRANSMIT DIAG Signal transmission status UNKWN ECM Signal receiving status from the ECM TCM Signal receiving status from the TCM METER/M&A Not used even though indicated STRG Signal receiving status from the steering angle sensor OK UNKWN ICC/ADAS Not used even though indicated AWD/4WD Signal receiving status from the transfer control unit OK UNKWN ITEM CAN DIAG SUP- PORT MNTR Description Normal Error PRESENT PAST PRESENT PAST IPDM-E TRANSMIT DIAG Signal transmission status OK OK or 1 – 39 * UNKWN 0 ECM Signal receiving status from the ECM BCM/SEC Signal receiving status from the BCM DTC Self-diagnosis item (CONSULT indication) DTC detection condition Inspection/Action U0101 LOST COMM (TCM) When ECM is not transmitting or receiving CAN commu- U0140 LOST COMM (BCM) When ECM is not transmitting or receiving CAN commu- U0164 LOST COMM (HVAC) When ECM is not transmitting or receiving CAN commu- U1000 CAN COMM CIRCUIT ECM When ECM is not transmitting or receiving Except When a control unit (except for ECM) is not U1001 CAN COMM CIRCUIT When ECM is not transmitting or receiving CAN commu- U1002 SYSTEM COMM When a control unit is not transmitting or receiving CAN Start the inspection. Refer U1010 CONTROL UNIT(CAN) When an error is detected during the initial diagnosis for Replace the control unit P0607 ECM August 2012 2012 Pathfinder |