|
|
REAR FINAL DRIVE DLN-477 < UNIT DISASSEMBLY AND ASSEMBLY > [REAR FINAL DRIVE: R230] C E F G H I J K L M A B DLN N O P 7. If the pulling force is outside the specification, use a thicker or thinner side bearing adjusting washer to adjust. Refer to 483, "Inspection and Adjustment" . CAUTION: Select a side bearing adjusting washer for right and left individually. 8. Record the total amount of washer thickness required for the correct side bearing preload torque. ASSEMBLY Drive Pinion Assembly 1. Install the drive pinion front and rear bearing outer races using Tools. CAUTION: Do not reuse drive pinion front and rear bearing outer race. 2. Select a drive pinion height adjusting washer. Refer to DLN-483, "Inspection and Adjustment" . 3. Install the selected drive pinion height adjusting washer to the drive pinion. Press the drive pinion rear bearing inner race to it using Tool. CAUTION: • Install the drive pinion height adjusting washer in the proper direction as shown. • Do not reuse drive pinion rear bearing inner race. If the pulling force is less than the specification: Use a thicker side bearing adjusting washer. If the pulling force is greater than the specification: Use a thinner side bearing adjusting washer. SPD772 Tool number (A): ST15310000 ( — ) SPD992 Tool number : ST30022000 ( — ) SPD377 August 2012 2012 Pathfinder |