|
|
STEERING COLUMN ST-19 < UNIT REMOVAL AND INSTALLATION > C D E F H I J K L M A B ST N O P STEERING COLUMN Removal and Installation INFOID:0000000006247245 CAUTION: • Do not exert any axial load or impact to the steering column. • Do not move the steering gear while the steering column assembly is removed. • Any time the ignition switch has been removed and installed, the keys must be re-registered in the BCM. Refer to CONSULT–III Operation Manual IVIS/NVIS. REMOVAL 1. Remove the spiral cable with the combination switches attached from the steering column assembly. SR-7, "Removal and Installation" . 2. Remove the instrument lower panel LH. Refer to IP-12, "Removal and Installation" . 3. Disconnect the following: • Ignition key lamp • Immobilizer • Ignition switch 4. Disconnect key interlock cable from steering column (if equipped). Refer to . 1. Driver air bag module 2. Steering wheel center nut 3. Steering wheel 4. Combination switch and spiral cable 5. Steering column assembly and igni- 6. Collar 7. Hole cover seal 8. Clamp 9. Hole cover mounting plate 10. Hole cover 11. Upper joint 12. Upper shaft 13. Boot clamp 14. Lower joint shaft 15. Boot and clips (plastic) AWGIA0198GB 2011 Pathfinder |