|
|
MA-52 < PERIODIC MAINTENANCE > CHASSIS AND BODY MAINTENANCE 1. Remove the filler plug and gasket from the rear final drive assembly. 2. Fill the rear final drive assembly with new differential gear oil until the level reaches the specified level near the filler plug hole. 3. Install the filler plug with a new gasket on it to the rear final drive assembly. Tighten to the specified torque. Refer to . CAUTION: Do not reuse gasket. WHEELS INFOID:0000000006827738 BALANCING WHEELS (ADHESIVE WEIGHT TYPE) Preparation Before Adjustment Remove inner and outer balance weights from the road wheel using releasing agent, remove double-faced adhesive tape from the road wheel. CAUTION: • Be careful not to scratch the road wheel during removal. • After removing double-faced adhesive tape, wipe clean all traces of releasing agent from the road wheel. Wheel Balance Adjustment • If a balancer machine has an adhesive weight mode setting, select the adhesive weight mode setting and skip Step 2. below. If a balancer machine only has the clip-on (rim flange) weight mode setting, follow Step 2. to calculate the correct size adhesive weight. 1. Set road wheel on balancer machine using the center hole as a guide. Start the balancer machine. late the correct size adhesive weight to use. When inner and outer imbalance values are shown on the balancer machine indicator, multiply outer imbalance value by 5/3 (1.67) to determine balance weight that should be used. Select the outer balance weight with a value closest to the calculated value above and install in to the designated outer position of, or at the designated angle in relation to the road wheel. a. Indicated imbalance value × 5/3 = balance weight to be installed Calculation example: 23 g (0.81 oz) × 5/3 (1.67) = 38.33 g (1.35 oz) ⇒ 40 g (1.41 oz) balance weight (closer to calculated balance weight value) NOTE: Note that balance weight value must be closer to the calculated balance weight value. Example: 37.4 ⇒ 35 g (1.23 oz) 37.5 ⇒ 40 g (1.41 oz) Differential gear oil : Refer to AND CANADA : Fluids and LLIA0068E SMA054D 2011 Pathfinder |