|
|
DLN-130 < PRECAUTION > [TRANSFER: ATX14B] PRECAUTIONS 5. When the repair work is completed, return the ignition switch to the ″ LOCK ″ position before connecting the battery cables. (At this time, the steering lock mechanism will engage.) 6. Perform a self-diagnosis check of all control units using CONSULT-III. Precaution for Transfer Assembly and Transfer Control Unit Replacement INFOID:0000000006245032 When replacing transfer assembly or transfer control unit, check the 4WD shift indicator lamp as follows. • If NG, the position is different between transfer assembly and transfer control unit. Adjust the position between transfer assembly and transfer control unit. See METHOD FOR POSITION ADJUSTMENT that follows. METHOD FOR POSITION ADJUSTMENT 1. Start engine. Run the engine for at least 10 seconds. seconds. 3. Turn 4WD shift switch to 2WD position. Stay in 2WD for at least 2 seconds. DLN-23, "CONSULT-III Function (ALL MODE AWD/4WD)" . 7. Check 4WD shift indicator lamp. Refer to . If 4WD shift indicator lamp does not indicate 2WD, install new transfer control unit and retry the above check. Precaution INFOID:0000000006245033 • Before connecting or disconnecting the transfer control unit harness connector, turn ignition switch “OFF” and disconnect battery cables. Failure to do so may damage the transfer con- trol unit. Battery voltage is applied to transfer control unit even if ignition switch is turned “OFF”. • When connecting or disconnecting pin connectors into or from transfer control unit, take care not to damage pin termi- nals (bend or break). When connecting pin connectors make sure that there are not any bends or breaks on transfer control unit pin terminals. SEF289H SEF291H 2011 Pathfinder |