|
|
FRONT DOOR GLASS AND REGULATOR GW-15 < REMOVAL AND INSTALLATION > C D E F G H I J L M A B GW N O P FRONT DOOR GLASS AND REGULATOR Front Door Glass INFOID:0000000005259826 REMOVAL 1. Remove the front door finisher. Refer to INT-14, "Removal and Installation" 2. Position aside the vapor barrier. window until the glass bolts can be seen. 5. Partially remove the inside seal. 7. While holding the door window, raise it at the rear and pull the glass out of the sash toward the outside of the door. INSTALLATION Installation is in the reverse order of removal. • Check the glass for proper fit. Follow the "FITTING INSPECTION" procedure. • On the drivers door, reset the motor. FITTING INSPECTION • Check that the glass is securely fit into the glass run groove. • Lower the glass slightly [approximately 10 to 20 mm (0.39 to 0.79 in)] and check that the clearance to the sash is parallel. If the clearance between the glass and sash is not parallel, loosen the regulator bolts, guide rail bolts, and glass and guide rail bolts to correct the glass position. Front Door Glass Regulator INFOID:0000000005259827 REMOVAL 1. Remove the front door finisher. Refer to INT-14, "Removal and Installation" 2. Position aside the vapor barrier. LIIA1686E LIIA1687E Glass bolts : 6.1 N·m (0.62 kg-m, 54 in-lb) 2010 Pathfinder |