|
|
CAMSHAFT VALVE CLEARANCE EM-161 < ON-VEHICLE MAINTENANCE > [VK56DE] C D E F G H I J K L M A EM N P O 7. Measure valve clearances at the locations marked “ × ” as shown in the table below (locations indicated with black arrow). : Engine front • (black): Measurable at No.1 cylinder compression top dead center • (white): Measurable at No. 3 cylinder compression top dead center • A: RH • Measure valve clearance using suitable tool. Refer to CAUTION: If the inspection was carried out with a cold engine, make 8. Turn the crankshaft pulley clockwise 270 ° from the position of No. 1 cylinder compression TDC to obtain No. 3 cylinder compression TDC. Measuring position (RH bank) No. 2 cyl (E) No. 4 cyl (F) No. 6 cyl (G) No. 8 cyl (H) No. 1 cylinder at TDC EXH
× INT × ×
Measuring position (LH bank) No. 1 cyl (J) No. 3 cyl (K) No. 5 cyl (L) No. 7 cyl (M) No. 1 cylinder at TDC INT × ×
EXH × × WBIA0713E KBIA0185E 2009 Pathfinder |