|
|
DLN-250 < SYMPTOM DIAGNOSIS > [TRANSFER: TX15B] 4WD WARNING LAMP DOES NOT TURN ON 4. CHECK INDICATOR LAMP CIRCUIT 1. Turn ignition switch “OFF”. (Stay for at least 5 seconds.) 2. Connect combination meter harness connector. 3. Disconnect transfer control unit harness connector. 4. Turn ignition switch "ON". (Do not start engine.) 5. Ground the following terminal using suitable wiring. - Transfer control unit harness connector M166 terminal 38 and Does the indicator lamp turn on? YES >> GO TO 5. NO >> Replace the combination meter. Refer to . 5. SYMPTOM CHECK Check again. Does the symptom still occur? YES >> GO TO 6. NO >> Inspection End. 6. CHECK TRANSFER CONTROL UNIT Check transfer control unit input/output signal. Refer to Are the inspection results normal? YES >> Inspection End. NO >> Check transfer control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts. SDIA3452E 2009 Pathfinder |