Nissan Pathfinder (2008 year). Manual - part 611
TM-230
< REMOVAL AND INSTALLATION >
TRANSMISSION ASSEMBLY
24. Remove A/T assembly with transfer from the vehicle using Tool.
CAUTION:
• Secure the torque converter to prevent it from dropping.
• Secure the A/T assembly to the transmission jack.
NOTE:
The actual special service Tool may differ from Tool shown.
25. Remove the transfer from the A/T assembly. Refer to
(ATX14B) or
(TX15B).
INSPECTION
Installation and Inspection of Torque Converter
• After inserting the torque converter to the transmission, be sure to
check dimension "A" to ensure it is within the reference value limit.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
• When replacing an engine or transmission you must make sure the dowels are installed correctly
during re-assembly.
• Improper alignment caused by missing dowels may cause vibration, oil leaks or breakage of driv-
etrain components.
• Do not reuse O-rings and copper washers. Refer to
• When turning crankshaft, turn it clockwise as viewed from the front of the engine.
• After converter is installed to drive plate, rotate crankshaft several turns and check to be sure that
transmission rotates freely without binding.
• When tightening the bolts for the torque converter while securing the crankshaft pulley bolt, be sure
to confirm the tightening torque of the crankshaft pulley bolt. Refer to
EM-185, "Removal and Installation"
When installing transmission to the engine, tighten the bolts to the specified torque as shown.
• For VQ40DE
Tool number
:
—
(J-47002)
SCIA2203E
Dimension "A"
VQ40DE Models
: 25.0 mm (0.98 in) or more
VK56DE Models
: 24.0 mm (0.94 in) or more
SAT017B
Transmission bolts
: 74 N·m (7.5 kg-m, 55 ft-lb)
LCIA0370E