|
|
INSPECTION AND ADJUSTMENT EC-493 < BASIC INSPECTION > [VK56DE] C D E F G H I J K L M A EC N P O 2. Rev engine (2,000 to 3,000 rpm) two or three times under no 3. Read idle speed in “DATA MONITOR” mode with CONSULT-III. Refer to EC-496, "Idle Speed and Ignition Without CONSULT-III 1. Run engine at about 2,000 rpm for about 2 minutes under no load. 2. Rev engine (2,000 to 3,000 rpm) two or three times under no load, then run engine at idle speed for about 3. Check idle speed. EC-496, "Idle Speed and Ignition Timing Check" OK or NG OK >> GO TO 10. NG >> GO TO 4. 4. PERFORM ACCELERATOR PEDAL RELEASED POSITION LEARNING 1. Stop engine. 2. EC-497, "Accelerator Pedal Released Position Learning" . >> GO TO 5. 5. PERFORM THROTTLE VALVE CLOSED POSITION LEARNING Perform EC-497, "Throttle Valve Closed Position Learning" . >> GO TO 6. 6. PERFORM IDLE AIR VOLUME LEARNING EC-497, "Idle Air Volume Learning" Is Idle Air Volume Learning carried out successfully? Yes or No Yes >> GO TO 7. No >> 1. Follow the instruction of Idle Air Volume Learning. 2. GO TO 4. 7. CHECK TARGET IDLE SPEED AGAIN With CONSULT-III 1. Start engine and warm it up to normal operating temperature. 2. Read idle speed in “DATA MONITOR” mode with CONSULT-III. EC-496, "Idle Speed and Ignition Timing Check" Without CONSULT-III PBIA8513J 650 ± 50 rpm (in P or N position) 650 ± 50 rpm (in P or N position) 650 ± 50 rpm (in P or N position) |