|
|
AP-10 < COMPONENT DIAGNOSIS > ADJUSTABLE PEDAL SYSTEM Pedal Adjusting Motor Circuit Inspection INFOID:0000000001726718 1. CHECK PEDAL ADJUSTING SWITCH 1. Turn ignition switch OFF. 2. Disconnect pedal adjusting switch. 3. Check continuity between pedal adjusting switch terminals as Is inspection result normal? YES >> GO TO 2 NO >> Replace pedal adjusting switch. 2. CHECK PEDAL ADJUSTING MOTOR HARNESS 1. Disconnect pedal adjusting motor. 2. Check continuity between pedal adjusting switch connector M96 3. Check continuity between pedal adjusting switch connector M96 Is inspection result normal? YES >> GO TO 3 NO >> Repair or replace harness. 3. CHECK PEDAL ADJUSTING MOTOR POWER SUPPLY 1. Connect pedal adjusting switch. 2. Check voltage between pedal adjusting motor connector E109 Is inspection result normal? Terminals Condition Continuity 3 1 Pedal adjusting switch forward. Continuity should exist. Pedal adjusting switch neutral. Continuity should not exist. 4 Pedal adjusting switch backward. Continuity should exist. Pedal adjusting switch neutral. Continuity should not exist. 2 1 Pedal adjusting switch backward. Continuity should exist. Pedal adjusting switch neutral. Continuity should not exist. 4 Pedal adjusting switch forward. Continuity should exist. Pedal adjusting switch neutral. Continuity should not exist. LIIA0897E 2 - 2 : Continuity should exist. 3 - 1 : Continuity should exist. 2 - Ground : Continuity should not exist. 3 - Ground : Continuity should not exist. ALJIA0168ZZ Connector Terminals Condition Voltage (V) (Approx.) (+) (-) E109 1 Ground Pedal adjusting switch forward Battery voltage Other than above 0 2 Pedal adjusting switch back- Battery voltage Other than above 0 ALJIA0169ZZ |