|
|
REAR DRIVE SHAFT RAX-7 C E F G H I J K L M A B RAX 2007 Pathfinder REAR DRIVE SHAFT PFP:39600 Components EDS003AO Rear Drive Shaft Assembly Removal and Installation EDS003AP REMOVAL 1. Remove the wheel and tire assembly using power tool. 2. Remove the cotter pin and discard, then remove the lock nut from the drive shaft. ● Do not reuse the cotter pin, discard after removal and use a new cotter pin for installation. 3. Remove the six rear drive shaft bolts from the rear final drive assembly flange using power tool. ● Do not reuse the rear drive shaft bolts, discard after removal and use new bolts for installation. 4. Separate the rear drive shaft from the rear wheel hub and bearing assembly by lightly tapping the end of 5. Remove the rear drive shaft. CAUTION: ● When removing the rear drive shaft, do not bend at an excessive angle to the rear drive shaft ● Do not excessively extend the slide joint. WDIA0230E 1. Rear final drive assembly 2. Rear drive shaft 3. Rear wheel hub and bearing assembly 4. Rear disc rotor 5. Cotter pin |