|
|
DTC P2101 ELECTRIC THROTTLE CONTROL FUNCTION EC-571 C D E F G H I J K L M A EC 2007 Pathfinder 10. CHECK ELECTRIC THROTTLE CONTROL ACTUATOR VISUALLY 1. Remove the intake air duct. 2. Check if foreign matter is caught between the throttle valve and OK or NG OK >> GO TO 11. NG >> Remove the foreign matter and clean the electric throttle control actuator inside. 11. CHECK THROTTLE CONTROL MOTOR Refer to EC-571, "Component Inspection" OK or NG OK >> GO TO 12. NG >> GO TO 13. 12. CHECK INTERMITTENT INCIDENT Refer to EC-145, "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT" OK or NG OK >> GO TO 13. NG >> Repair or replace harness or connectors. 13. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR 1. Replace the electric throttle control actuator. 2. Perform EC-77, "Throttle Valve Closed Position Learning" . 3. Perform EC-77, "Idle Air Volume Learning" . >> INSPECTION END Component Inspection UBS00KCA THROTTLE CONTROL MOTOR 1. Disconnect electric throttle control actuator harness connector. 2. Check resistance between terminals 5 and 6. 3. If NG, replace electric throttle control actuator and go to next 4. Perform EC-77, "Throttle Valve Closed Position Learning" . 5. Perform EC-77, "Idle Air Volume Learning" . Removal and Installation UBS00KCB ELECTRIC THROTTLE CONTROL ACTUATOR Refer to EM-17, "INTAKE MANIFOLD COLLECTOR" . BBIA0554E Resistance: Approximately 1 - 15 Ω [at 25 ° C (77 ° F)] PBIB2606E |