|
|
AUTOMATIC DRIVE POSITIONER SE-61 C D E F G H J K L M A B SE 2006 Pathfinder 2. CHECK SLIDING SWITCH CIRCUIT HARNESS CONTINUITY 1. Disconnect driver seat control unit connector and power seat 2. Check continuity between driver seat control unit connector P2 3. Check continuity between driver seat control unit connector P2 OK or NG OK >> GO TO 3. NG >> Repair or replace harness. 3. CHECK SLIDING SWITCH Check continuity between power seat switch LH as follows. OK or NG OK >> Replace driver seat control unit. Refer to NG >> Replace power seat switch LH. Refer to 11 - 7 : Continuity should exist. 26 - 1 : Continuity should exist. 11 - Ground : Continuity should not exist. 26 - Ground : Continuity should not exist. LIIA1125E Terminal Condition Continuity 7 3 Sliding switch ON (BACKWARD operation) Yes Other than above No 1 Sliding switch ON (FORWARD operation) Yes Other than above No LIIA1126E |