|
|
AUTOMATIC DRIVE POSITIONER SE-51 C D E F G H J K L M A B SE
2005 Pathfinder 4. CHECK MIRROR MOTOR SIGNAL 1. Connect automatic drive positioner control unit. 2. Turn ignition switch to ACC. 3. Check voltage between door mirror RH connector and ground. OK or NG OK >> Replace door mirror motor RH. Refer to . NG >> Replace automatic drive positioner control unit. Sliding Sensor Circuit Inspection EIS0045M 1. CHECK FUNCTION With CONSULT-II Check operation with “SLIDE PULSE” on the DATA MONITOR to make sure the pulse changes. Without CONSULT-II 1. Turn ignition switch OFF. 2. Check signal between driver seat control unit connector and OK or NG OK >> Sliding sensor circuit is OK. NG >> GO TO 2. Connector Terminals Condition Voltage (V) (Approx.) (+) (–) D107 3 Ground Mirror motor is operated 1.5 - Battery voltage Other than above 0 2 Mirror motor is operated 1.5 - Battery voltage Other than above 0 8 Mirror motor is operated 1.5 - Battery voltage Other than above 0 LIIA1762E Monitor item [OPERATION or UNIT] Contents SLIDE PULSE — The seat sliding position (pulse) judged PIIA4558E Connector Terminals Condition Signal (+) (–) P2 24 Ground Sliding PIIA4556E PIIA3277E |