|
|
ENGINE ASSEMBLY EM-103 < UNIT REMOVAL AND INSTALLATION > C D E F G H I J K L M A EM N P O • For supporting, lifting and jacking points, refer to • Always use the support point specified for lifting. • Support the vehicle at the rear axle jacking point with transmission jack or similar tool before remov- ing the engine in preparation for the backward shift of the center of gravity. NOTE: When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spill- ing. REMOVAL Outline Remove the engine and transaxle with the front suspension member as a unit. Separate the engine from the transaxle and remove from the front suspension member. Preparation 1. Release fuel pressure. Refer to 2. Drain engine coolant. Refer to CO-11, "Changing Engine Coolant" CAUTION: • Perform this step when the engine is cold. • Do not allow the engine coolant to contact the drive belts. 3. Remove the engine under cover. Refer to EXT-17, "Removal and Installation" . 4. Remove the front road wheels and tires using a power tool. Refer to . 5. Remove the fender protector side covers (RH and LH): Refer to . 6. Remove the hood lock switch assembly. Refer to DLK-299, "HOOD LOCK RELEASE CABLE : Removal Engine Room 1. Remove the air duct (inlet), air cleaner cases (upper and lower) with mass air flow sensor and air duct assembly. Refer to EM-24, "Removal and Installation" 2. Remove the engine room cover. Refer to EM-23, "Removal and Installation" 3. Drain the power steering fluid. Refer to ST-42, "Draining and Refilling" . 4. Disconnect engine room harness at the CVT and ECM connectors. CAUTION: Protect the harness connector with plastic bags or suitable covering to help prevent damage and intrusion of foreign materials into the connectors. 5. Remove the battery and battery tray. Refer to PG-90, "Removal and Installation" . 6. Remove battery bracket with ECM and CVT module. EXT-25, "Removal and Installation" 10. Remove the front wiper drive assembly. Refer to WW-65, "Removal and Installation" 11. Remove the lower cowl panel. Refer to EXT-25, "Removal and Installation" 12. Disconnect heater hoses. Refer to HA-44, "HEATER CORE : Removal and Installation" . 13. Remove engine cooling fan shroud and motor assembly. Refer to CO-17, "Removal and Installation" 14. Remove upper and lower radiator hoses. Refer to CO-15, "Removal and Installation" 15. Remove the radiator. Refer to CO-15, "Removal and Installation" . 16. Remove EVAP hose. Refer to EC-14, "ENGINE CONTROL SYSTEM : Component Parts Location" . 17. Disconnect fuel feed hose quick connector at fuel tube side. Refer to 18. Disconnect transaxle shift control cable at transaxle side. Refer to . 19. Disconnect brake booster vacuum hose at brake booster. Refer to 20. Remove harness ground cable. ST-55, "Removal and Installation" . 22. Disconnect high pressure piping from steering pump. Refer to ST-55, "Removal and Installation" . |