|
|
Content .. 1158 1159 1160 1161 ..
P0705 TRANSMISSION RANGE SENSOR A TM-99 < DTC/CIRCUIT DIAGNOSIS > [CVT: RE0F10E] C E F G H I J K L M A B TM N O P P0705 TRANSMISSION RANGE SENSOR A DTC Logic INFOID:0000000009177560 DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2. CHECK DTC DETECTION 1. Turn ignition switch ON. 2. Shift the selector lever through entire positions from “P” to “L”. (Hold the selector lever at each position for 5 seconds or more.) 3. Check the first trip DTC. YES >> Go to NO >> INSPECTION END Diagnosis Procedure INFOID:0000000009177561 1. CHECK TCM INPUT SIGNALS With CONSULT 1. Turn ignition switch ON. 2. Select “Data Monitor” in “TRANSMISSION”. 3. Select “D POSITION SW”, “N POSITION SW”, “R POSITION SW”, “P POSITION SW” and “L RANGE SW”. 4. Shift the selector lever through entire positions from “P” to “L” and check ON/OFF of each monitor item. Without CONSULT 1. Turn ignition switch OFF. 2. Disconnect TCM connector. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P0705 T/M RANGE SENSOR A When all of the following conditions are satis- stay ON continuously • TCM power supply voltage: More than 11 V • Harness or connector (Short circuit between transmission • Transmission range switch Monitor item Condition Condition D POSITION SW Selector lever: “D” position On Other than the above Off N POSITION SW Selector lever: “N” position On Other than the above Off R POSITION SW Selector lever: “R” position On Other than the above Off P POSITION SW Selector lever: “P” position On Other than the above Off L POSITION SW Selector lever: “L” position On Other than the above Off |