|
|
FL-6 < REMOVAL AND INSTALLATION > FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY Removal and Installation INFOID:0000000007564921 WARNING: Read “General Precautions” when working on the fuel system. Refer to REMOVAL 1. Check fuel level on a level ground. If the fuel level is 7/8 of the fuel tank (full or nearly full), draw appropri- • In the event of malfunction in fuel pump, insert a hose measuring 25 mm (0.98 in) in diameter into the filler opening to draw approximately 20 liters fuel. 2. Release the fuel pressure from the fuel lines. Refer to . 3. Open fuel filler lid. 4. Open filler cap and release the pressure inside fuel tank. 5. Remove rear seat cushion and reclining device assembly. Refer to 6. Remove inspection hole cover. Refer to 7. Peel off floor carpet, then remove inspection hole cover units by 1. Sub fuel level sensor unit 2. Sub fuel level sensor unit base 3. Fuel filter and fuel pump assembly 4. Fuel level sensor unit : Vehicle front PBIC4901J Guideline : Draw approximately 20 liters from a full-tank condition Left side : Main fuel level sensor unit, fuel filter Right side : Sub fuel level sensor unit SBIA0479E Revision: 2013 February 2012 Murano CrossCabriolet |