|
|
TROUBLE DIAGNOSIS SRS-29 C D E F G I J K L M A B SRS Revision: 2006 August 2006 Murano 3. Touch “TROUBLE DIAG RECORD”. NOTE: 4. Diagnostic code is displayed on “TROUBLE DIAG RECORD”. 5. Touch “PRINT”. 6. Compare diagnostic codes to SRS-29, "DTC No. Index (“SELF- DIAG [PAST]” or “TROUBLE DIAG RECORD”)" 7. Touch “BACK” key of CONSULT-II until “SELECT SYSTEM” 8. Turn ignition switch OFF, then turn off and disconnect CON- 9. Repair the system as outlined by the “Repair order” in “Intermit- 10. Go to , for final checking. SRS-26, "DIAGNOSTIC PROCEDURE 3" . DTC No. Index (“SELF-DIAG [PAST]” or “TROUBLE DIAG RECORD”) SRS697 SHIA0182E Diagnostic item Explanation Repair order “Recheck SRS at each replacement” NO DTC IS DETECTED. When malfunction is ● Low battery voltage (Less than 9V) ● Go to ● No malfunction is detected. ● Go to DRIVER AIRBAG ● Driver air bag module circuit is open (including the spiral cable). 1. Visually check the wiring harness connection. 2. Replace the harness if it has visible damage. 3. If the harness check result is OK, replace driver air bag module, diag- DRIVER AIRBAG ● Driver air bag module circuit is shorted to a power supply circuit DRIVER AIRBAG ● Driver air bag module circuit is shorted to ground (including the DRIVER AIRBAG ● Driver air bag module circuit is shorted between lines. |