|
|
DTC P0845 TRANSMISSION FLUID PRESSURE SENSOR B CIRCUIT (PRI PRESSURE SENSOR) CVT-145 D E F G H I J K L M A B CVT Revision; 2004 April 2003 Murano Remarks: Specification data are reference values. Diagnostic Procedure ACS002TW 1. CHECK INPUT SIGNAL (WITH CONSULT-II) With CONSULT-II 1. Start engine. 2. Select “ECU INPUT SIGNALS” in “DATA MONITOR” mode for 3. Start vehicle and read out the value of “PRI HYDR SEN”. OK or NG OK >> GO TO 6. NG >> GO TO 3. 2. CHECK INPUT SIGNAL (WITHOUT CONSULT-II) Without CONSULT-II 1. Start engine. 2. Check voltage between TCM connector and ground. OK or NG OK >> GO TO 6. NG >> GO TO 3. 3. CHECK SENSOR POWER AND SENSOR GROUND 1. Turn ignition switch “ON”. (Do not start engine) 2. Check voltage between TCM connector 46 and 42. OK or NG OK >> GO TO 5. NG >> GO TO 4. Terminal No. Wire color Item Condition Judgement standard (Approx.) 41 V/O Transmission fluid N position idle 0.7 - 1.2V Monitor item Condition Specification (Approximately) PRI HYDR SEN N position idle 0.7V - 1.2V During driving [40 km/h (25 MPH)] 1.0V SCIA2277E Name Connector No. Terminal No. Condition Voltage (Approx.) Transmission fluid F104 41 (V/O) - ground “ N” position idle 0.7 - 1.2V SCIA4509E Item Connector No. Terminal No. (Wire color) Data (Approx.) TCM connector F104 46 (L/O) - 42 (W/R) 5V SCIA2367E |