|
|
EC-376 < COMPONENT DIAGNOSIS > [VQ35DE] P1554 BATTERY CURRENT SENSOR YES >> GO TO 5. NO >> Repair open circuit, short to ground or short to power in harness or connectors. 5. CHECK BATTERY CURRENT SENSOR EC-376, "Component Inspection" Is the inspection result normal? YES >> GO TO 6. NO >> Replace battery negative cable assembly. 6. CHECK INTERMITTENT INCIDENT GI-40, "Intermittent Incident" >> INSPECTION END Component Inspection INFOID:0000000003664589 1. CHECK BATTERY CURRENT SENSOR 1. Turn ignition switch OFF. 2. Reconnect harness connectors disconnected. 3. Disconnect battery negative cable (1). - : Vehicle front - : To body ground 4. Install jumper cable (A) between battery negative terminal and 5. Turn ignition switch ON. 6. Check the voltage between ECM harness connector terminals Before measuring the terminal voltage, confirm that the battery is fully charged. Refer to . Is the inspection result normal? YES >> INSPECTION END NO >> Replace battery negative cable assembly. ECM Voltage (V) Connector + – Terminal Terminal F8 42 (Battery current sensor signal) 44 (Sensor ground) Approx. 2.5 ALBIA0076ZZ Revision: 2008 October 2009 Murano |