|
|
содержание .. 1284 1285 1286 1287 ..
FAX-136 < REMOVAL AND INSTALLATION > [4WD] FRONT DRIVE SHAFT • Check boot for cracks, damage, and leakage of grease. is a non-standard condition. INSPECTION AFTER DISASSEMBLY Shaft Check shaft for runout, cracks, or other damage. Replace if there are. Dynamic Damper (If equipped) Check damper for cracks or wear. Replace if necessary. Joint Sub-Assembly (Wheel Side) Check the following: Housing and Spider assembly (Transaxle Side) Replace housing and spider assembly if there is scratching or wear of housing roller contact surface or spider Support Bearing (Right Side) Make sure wheel bearing rolls freely and is free from noise, cracks, pitting or wear. Replace support bearing if Support Bearing Bracket (Right Side) Check for bending, cracks, or damage. Replace support bearing bracket if there are any non-standard condi- INSPECTION AFTER INSTALLATION 1. Check wheel sensor harness for proper connection. Refer to BRC-212, "FRONT WHEEL SENSOR : . 2. Check the wheel alignment. Refer to . 3. Adjust neutral position of steering angle sensor. Refer to . SDIA1190J |